Configuration of Ethernet
If no wifi is connected the screen will connect to Ethernet automatically
- Press Home + 1888 fast on the remote. You may need to pull out the IR receiver on the backside of the monitor.
- Chose network
- Chose Ethernet.
- Verify that Ethernet is enabled. When it is enabled the screen will connect if there is no additional network configuration needed as static ip-addresses or such.
- Press the back button 3 times.
Configuration of Wifi
- Press Home + 1888 fast on the remote. (You may need to pull out the IR receiver on the side of the tv)
- Chose Network
- Chose Wi-Fi
- Chose the network that you want to connect to and press OK
- Enter a password if needed
- If the correct password is entered The status if the connection shall be "connected".
- Press the back button 3 times.